FAQ's
On our faq page, you can find questions about flooring underlayment and floor heating systems. Get helpful information to assist with your purchase decisions and address any concerns you may have.
Filter
If you are looking for a test report please send an email to [email protected] and specify the product and type of report you are needing. We would be more than happy to email you a copy of any testing data that we have.
To clean ParkPad, we recommend you wash off dirt and grime with a mild dish detergent and water. We do not recommend you attempt to wash large amounts of motor oil out of your ParkPad, as motor oil is an environmental hazard. Please replace ParkPad if it becomes saturated with any type of chemical that can contaminate the soil or ground water.
Yes, our ParkPad product is wrapped in plastic for shipping.
The ParkPad backing will not “melt” in the heat of your garage. It does not stick to surfaces, even when warm. However, please ensure your paint is fully cured prior to placing ParkPad over it.
AbsorbaSound can be used in place of a cement board or uncoupling mat.
AbsorbaSound is a sound barrier that will help to reduce the transfer of noise between levels, in either direction.
AbsorbaSound is designed to be installed under your floor covering. We cannot attest to the effectiveness when used under an area rug.
AbsorbaSound is suitable for use under ceramic tile. We would feel confident in the use of our product in the application described, however we would recommend getting approval from the manufacturer of the uncoupling membrane as well.
AbsorbaSound comes in various thicknesses. The 2mm thick product, 200 square foot roll will weigh approximately 75lbs. Other thicknesses are listed on our spec sheet which can be viewed on the AbsorbaSound product page.
AbsorbaSound is not currently approved for use under turf products, as we have no testing data to determine suitability.