If you are looking for a test report please send an email to [email protected] and specify the product and type of report you are needing. We would be more than happy to email you a copy of any testing data that we have.
To clean ParkPad, we recommend you wash off dirt and grime with a mild dish detergent and water. We do not recommend you attempt to wash large amounts of motor oil out of your ParkPad, as motor oil is an environmental hazard. Please replace ParkPad if it becomes saturated with any type of chemical that can contaminate the soil or ground water.
Yes, our ParkPad product is wrapped in plastic for shipping.
The ParkPad backing will not “melt” in the heat of your garage. It does not stick to surfaces, even when warm. However, please ensure your paint is fully cured prior to placing ParkPad over it.
The MoistureBlock should be installed over the concrete, then the QuietWalk Luxury Vinyl with the film side up, and then your floor covering.
MoistureBlock can be used over concrete with an embedded heat system, provided the heating element is at least 1/2″ below the surface.
MoistureBlock has not been tested for use with adhesives. Verify with your adhesive manufacturer to see if they have a product that will bond to a polyethylene film.
MoistureBlock has not been tested for use in crawl spaces.
MoistureBlock is an effective vapor barrier approved for use under fully installed floor coverings.
MoistureBlock should be installed just prior to installing your floor covering.