FAQ's
On our faq page, you can find questions about flooring underlayment and floor heating systems. Get helpful information to assist with your purchase decisions and address any concerns you may have.
Filter
If you are looking for a test report please send an email to [email protected] and specify the product and type of report you are needing. We would be more than happy to email you a copy of any testing data that we have.
To clean ParkPad, we recommend you wash off dirt and grime with a mild dish detergent and water. We do not recommend you attempt to wash large amounts of motor oil out of your ParkPad, as motor oil is an environmental hazard. Please replace ParkPad if it becomes saturated with any type of chemical that can contaminate the soil or ground water.
Yes, our ParkPad product is wrapped in plastic for shipping.
The ParkPad backing will not “melt” in the heat of your garage. It does not stick to surfaces, even when warm. However, please ensure your paint is fully cured prior to placing ParkPad over it.
The MoistureBlock should be installed over the concrete, then the QuietWalk Luxury Vinyl with the film side up, and then your floor covering.
QuietWalk LV is installed with the film side up and fiber side down.
QuietWalk LV will absolutely help to reduce noise transfer between levels.
QuietWalk LV is approved for use with luxury vinyl plank.
QuietWalk LV is not approved for use with carpet. We recommend our QuietWalk Carpet Pad.
QuietWalk LV is approved for use with QuietWarmth Float, but we recommend installing the underlayment first and then the heat mats on top.
QuietWalk Luxury Vinyl has a PERM rating of 0.06.
QuietWalk LV would be perfect for use with an 8mm thick SPC flooring. It was designed for just that use!